Installation Of Item No. 1341087 - oventrop 1341088 Notice D'utilisation

Installation
Illust. 8: Installation of the copper pipe Regudis
W-HTO
8. Bend the copper pipe if necessary. Correct the
orientation of the valve.
9. Tighten the union nuts at the copper pipe.
10. Check all installation points for leaks.
5.3

Installation of item no. 1341087

Procedure for: Derivative temperature control set
item no. 1341087 for Regudis W-HTO Duo
1. Close the ball valves.
2. Drain the dwelling station via the drain valve.
3. Unscrew (22 mm spanner) the blind plug from the
distributor (see Illust. 9).
4. Unscrew (12 mm spanner) the sealing plug from
the body (see Illust. 9).
Keep a cloth and a container at hand to collect
escaping water.
16
Derivative temperature control set
1
2
Illust. 9: Removal of the plugs Regudis Regudis
W-HTO Duo
(1)
Body
(2) Sealing plug (12 mm spanner)
(3) Blind plug (22 mm spanner)
(4)
Drain valve
5. Screw the adapter (see Illust. 1) into the body.
6. Loosen the union nuts and the pipe clamps at the
body.
Illust. 10: Installation of the adapter Regudis W-HTO
Duo
(1) Union nut (32 mm spanner)
(2)
Adapter (16 mm spanner)
7. Screw the valve into the distributor (see Illust. 11).
3
4
1
2
134108880-V01.11.2020