Makita DTD145 Manuel D'instruction page 7

NOTE:
When all lamps on the switch panel go out, the
•
tool is turned off to save the battery power. The
hammer force grade can be checked by pulling the
switch trigger to the extent that the tool does not
operate.
During the operation of switch trigger, the hammer
•
force grade cannot be changed.
Empty signal for remaining battery capacity
(Country specific)
014071
Pulling the trigger switch when the remaining battery
capacity becomes very low makes LED indicator flicker.
If the tool is used continuously with the LED indicator
flickering up and the battery power is almost used up,
the LED indicator will light up and the tool itself will stop.
Please refer to the following table for the LED indicator
status and the remaining battery capacity.
LED indicator status
OFF
Flickering
Lighting on
011188
NOTE:
When all lamps on the switch panel go out, the
•
tool is turned off to save the battery power. The
remaining battery capacity can be checked by
pulling the switch trigger to the extent that the tool
does not operate.
All of the lamps on the switch panel go out
•
approximately one minute after releasing the
switch trigger.
When the tool temperature is high, the LED
•
indicator may flicker or light up.
If the LED indicator lights up and the tool stops
•
even with a recharged battery cartridge, cool down
the tool temperature fully. When the status is still
unchanged, stop using and have the tool repaired
by a Makita local service center.
1. LED indicator
S H
1
Remaining battery capacity
Enough
20%
Very low and the tool will stops
Indicating the remaining battery capacity
(Only for battery cartridges with "B" at the end of the
model number.)
015676
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for few seconds.
Indicator lamps
Lighted Off
015658
NOTE:
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
7
1. Indicator lamps
2. Check button
1
2
Blinking
75% to 100%
50% to 75%
25% to 50%
Charge the
The battery
malfunctioned.
Remaining
capacity
0% to 25%
battery.
may have