Connecting The Power Cord - Pioneer PureVision PDP-5050SX Mode D'emploi

Preparation

Connecting the power cord

Connect the power cord after all component connections have been completed.
Plasma Display (rear view)
ANTENNA B
IN
Cable
ANTENNA/
CARD
CABLE A IN
MONITOR R-AUDIO-L
VIDEO
OUT
INPUT 2
SERVICE ONLY
OUT
S-VIDEO VIDEO R-AUDIO-L
• Use only the supplied power cord.
• Be sure to use the specified power supply voltage;
neglecting this can result in fire or electric shock.
• For the Plasma Display System, a three-core power cord
with a ground terminal is used for efficiency protection.
Always connect the power cord to a three-pronged
outlet and make sure that the cord is properly grounded.
06-PDP5050SX-Eng (14-19)
DIGITAL OUT CONTROL
OUT
OPTICAL
R-AUDIO-L
VIDEO R-AUDIO-L Y C /P C /P INPUT 1
B B R R
COMPONENT
VIDEO
COMPONENT
HDMI
VIDEO
S-VIDEO R-AUDIO-L Y C B /P B C R /P R INPUT 4 INPUT 3
19
SPEAKERS
AC IN
Power cord
Noise filter
Partially eliminates noise
caused by the power source.
• Always turn off the power of the Plasma Display when connecting
the power cord.
• Disconnect the power cord from the power outlet when the Plasma
Display System is not going to be used for a long period of time.
05.2.25, 0:15 PM
06
19
En