Cleaning And Maintenance - Dometic 5 Série Instructions De Montage

Cleaning and maintenance

D+ (RMV5305 only)
In automatic mode, the refrigerator selects the most favourable mode available. The
refrigerator is only operated with direct current when the vehicle engine is running.
The electronics of the refrigerator uses the signal D+ from the light system to detect
the running engine.
➤ Connect the D+ connection to the controls (fig. e D, page 10) with the respec-
tive terminal of the vehicle.
S+ (RMV5305 only)
In automatic mode, the refrigerator is first powered with DC power from the vehi-
cle's own solar system. The refrigerator electronics uses the S+ signal of the solar
charge controller to detect a solar system. The solar charge controller must have an
AES output.
➤ Connect the S+ connection on the controller (fig. e E, page 10) to the respec-
tive terminal of the solar charge controller.
Suitable solar charge controllers are available from specialist dealers.
The manufacturer recommends, for example:
• Büttner MT 300-S
(www.buettner-elektronik.de)
• Votronic MPP 240 Duo Digital
(www.votronic.de)
10 Cleaning and maintenance
!
WARNING!
Always disconnect the refrigerator from the mains before you clean and
service it.
A
NOTICE! Beware of damage
• Do not allow grease or oil to come into contact with the door seal.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the refrigerator.
➤ Occasionally clean the refrigerator interior and exterior with a damp cloth.
➤ Make sure that the air vents on the refrigerator are free of any dust and dirt so that
heat can be released and the refrigerator is not damaged.
24
RMV5301, RMV5305
EN