Velleman AVMOD16N Mode D'emploi page 2

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
1. Redirect the TV/radio antenna.
2. Relocate the receiver away from the TV/radio receiver.
3. Plug the receiver into a different power outlet so that the receiver is on a different branch of the circuit.
4. If necessary, the user should consult the dealer or an experienced technician for additional suggestions.
b. Notice
The user is cautioned that changes or modifications not expressly approved by the manufacturer could void the
user's authority to operate the equipment. Linear radio controls provide a reliable communication link and fill an
important need in portable wireless signalling. However, there are some limitations which must be observed.
The radios are required to comply with FCC rules and regulations as Part 15 devices and CE I-ETS 300 440. As
such, they have limited transmitter power and therefore limited range. A receiver cannot respond to more than one
transmitted signal at a time and may be blocked by radio signals that occur on or near their operating frequencies.
4. Description
Camera
1. Protection cover
2. IR LEDs
3. Stand connection
4. Power jack
5. Microphone
6. Antenna
7. Channel switch
8. Power adapter plug
9. Stand
Receiver
1. Antenna
2. Power LED
3. DC input jack
4. Channel switch
5. A/V cable
6. Power adapter
7. A/V connection cable
5. Installing and Connecting the Camera
AVMOD16N / AVMOD16CCN
Select a suitable mounting location, i.e. dry, dust-free with good
air circulation and as little vibrations as possible. Make sure
there is a mains in the vicinity. Also, make sure the mounting
location is not screened off by reinforced concrete walls,
mirrors, metal shelves etc. Remove any appliance with a strong
magnetic field causing interference and reducing the camera's
performance.
- 2 - VELLEMAN