Kratki VIKING Instructions De Montage page 44

MENU KONFIGURACJA
Menu Konfiguracja pozwala na ustawienie podstawowych parametrów pracy wyświetlacza takich jak
język, kontrast i podświetlenie. Aby wejść do Menu Konfiguracja należy na panelu dotykowym wcisnąć
i przez trzy sekundy przytrzymać przycisk P3. Poruszanie się po menu i edycja parametrów zgodnie
z tabelą 3.
Lista pozycji dla Menu Konfiguracja:
- Konfiguracja Klawiatury
- Czas i Data
- Język
- Menu Wyświetlacza
- Kontrast
- Podświetlenie
- Lista Adresów
- Menu Systemowe (FOR AUTHORIZED COMPETENT SERVICE ONLY)
Table 5. Configuration Menu
Item Description
Date & Time The current date and time settings.
Keypad Config
Language This function provides a selection of languages for the display interfa-
ce. You can choose one of the 14 languages available.
Contrast This function adjusts the display contrast. You can set the contrast level
between 0 and 30.
Backlight This defines the display backlight brightness when not in use. You can
Display Menu
set the backlight brightness level between 0 and 20.
Address List This screen shows the firmware version data of the touch control
panel.
For authorized competent service only: Modifying any setting in this menu may
System Menu
cause malfunctions of the pellet stove or render it inoperable. All settings the cu-
stomer is authorized to modify are listed in the previous sections.
MAINTENANCE
CAUTION!
Do not attempt any maintenance before the heating appliance cools down (which takes ap-
proximately 1 hour). Disconnect the heating appliance from the mains before maintenance.
Have the pellet stove and its air and flue gas systems maintained by competent technical
service personnel only.
The heating appliance requires regular cleaning. If the heating appliance was not used for a long time,
its entire flue vent duct and chimney system and the combustion air intake duct must be inspected
for obstructions.
TROUBLESHOOTING
If the touch control panel display reads any of the following messages, find it in the error description
below. If an error occurs when the pellet stove is heating, it will automatically stop the combustion
process. The turn-off process continues until the flue gas temperature at the flue exhaust fan outlet
is reduced to 55°C. Next, the pellet stove will enter the lockdown mode. To clear the error and lift the
lockdown, press and hold P2 for 3 seconds. The display will read "Off". If the error persists despite it
44