Kratki VIKING Instructions De Montage page 43

Mode
You can have the pellet stove running in one of the three modes:
Daily: the schedule is set separately for each day of the week; if active, C is di-
splayed.
Weekly: the schedule is set for the whole week; if active, T is displayed.
Weekend: the schedule is set separately for the days from Monday to Friday and
from Saturday to Sunday; if active, KT is displayed.
Press P3. Next, press P6 and P4 to choose the mode and enable it by pressing P2.
The OFF message in the top left corner of the display will change to ON. Save the
changes by pressing P3 again. The start screen of the display will display with C,
T, or KT, depending on the CHRONO mode enabled.
Schedule
The controller accepts the schedule settings in one of the three modes:
Daily: the schedule is set separately for each day of the week.
Weekly: the schedule is set for the whole week.
Weekend: the schedule is set separately for the days from Monday to Friday and
from Saturday to Sunday. First, use P6 and P4 to select the mode schedule to be
set. Enter the selected mode settings with P3. Set the time at which the pellet
stove should start heating and the time it should start turning off. A maximum of
three ignition and turn-off cycles can be scheduled per 24 hours.
CHRONO
Turn-off time control setting
- Navigate to the running hours bar with P6 and P4.
- Press P3 to choose the running hours (the selection is flashing).
- Set the running hours with P6 and P4.
- Save changes by pressing P3.
- Enable the turn-off time control with P5 (when enabled, the check mark to the
right is displayed).
Night-time setting
Set the ignition time of the pellet stove on the current day (e.g. 20:30), and follow by
setting the turn-off time on the same day (e.g. 23:59). Next, set the ignition time on
the next day (e.g. 00:00) and the turn-off time on the same day (e.g. 6:30). According
to this example, the pellet stove will be ignited at 20:30 of the same day and turned off
at 6:30 on the next day.
This feature charges the pellets with the automatic auger from the pellet hopper
to the combustion chamber when the pellet stove is not ignited or heating.
Fill Auger
When the auger is completely filled, stop the process by pressing P1. The pellet
stove must not be fired for the Fill Auger function to work.
43