Installation Location - Kratki VIKING Instructions De Montage

Table 2. List of the control system components of the VIKING pellet stove
Designation
Flow meter
Pellet sensor
Thermostat
Ceramic igniter
Encoder motor
Encoder controller cable
Flue exhaust fan
Air fan
Power cord
Power switch
Wire, white, H05V-K 1mm
Wire, black, H05V-K 1mm
Wire, red, H05V-K 1mm
Wire, blue, H05V-K 1mm
Wire, yellow/green, H05V-K 1mm
Insulated bush, NCI 6.3-2.5/0.8 PVC
Igniter guard
CAUTION: This heating appliance is not compatible with concentric flue vent ducts!

INSTALLATION LOCATION

Specify the location in which the pellet stove will be installed. The pellet stove should be installed with
the air intake duct and the flue vent adapter duct featuring as few bends as possible. This will assure
the right chimney draught. The clearance to combustible walls and flammable materials around the
pellet stove shall be: 100 mm from the back, 300 mm from each side and a radius of 1000 mm from
the front glass. Never position the pellet stove near flammable materials, including wooden furniture,
carpets, rugs, or drapes/curtains. Do not leave clothes, towels, etc. to dry near the pellet stove, or the
may catch fire. The pellet stove shall sit on a firm and non-combustible base (floor).
Wybierając lokalizację dla ogrzewacza należy rozważyć kolejne punkty:
- The location of the room in the building the pellet stove is to be installed in
- The required minimum clearances from flammable materials
- Ventilation requirements
- The installation orientation and place
- The air ventilation system
- The general power outlet connection
Checks
- Controller
Part number
PACCS11000001
PACCS10000001
0SEN1EL001304
0RESRV000003
0SER1AT000010
0CABVCC000510
0VENATA000609
0VENATA000602
OPRE110000504
PACCI16000403
PRZEWOD/H05V-K/BIALY
PRZEWOD/H05V-K/CZARNY
PRZEWOD/H05V-K/CZERWONY
PRZEWOD/H05V-K/NIEBIESKI
PRZEWOD/H05V-K/ZOLTO-ZIELONY
KONEKTOR/6,3/2,5/0,8
PACC0000012
31