Kratki VIKING Instructions De Montage page 40

OPERATING INSTRUCTIONS
These instructions specify the general rules for a safe operation of the heating appliance according to
its intended use, and the procedures for operating the heating appliance with its control panel. Failure
to comply with these instructions may result in improper, non-efficient or hazardous operation of the
heating appliance, including damage to the heating appliance and/or other property, and/or injury to
the operator and/or bystanders.
OPERATING PRINCIPLE OF THE PELLET STOVE
Combustion of wooden pellets generates heat. The wooden pellets are stored in the pellet hopper in-
stalled in the top left-hand section of the pellet stove. The wooden pellets are fed from the pellet hop-
per to the hearth's combustion chamber by a gear-motor-powered auger. During the ignition stage of
the heating cycle, the pellets fed to the combustion chamber are ignited by a jet of hot air, brought to
the ignition temperature by the ceramic igniter. The flue gas generated by combustion of the pellets
is exhausted via the flue vent duct; the exhaust rate depends on the flue exhaust fan operation. The
entire operating process of the pellet stove can be controlled with the touch control panel located in
the top left corner in the front of the pellet stove (see Fig. 1).
Do not place any objects, living beings, biomass or other materials in the combustion cham-
ber of the hearth. The combustion chamber must be empty.
CONTROLLER OPERATING MANUAL
Read this Controller Operating Manual before starting the heating appliance for the first time. Impro-
per use of the controller may result in malfunctioning of the heating appliance or a failure of starting
the heating appliance.
OVERVIEW OF THE TOUCH CONTROL PANEL
CHRONO mode
Fig. 10. Overview of the touch control panel of the VIKING pellet stove
40
Day and time
Status
Heat output level
Heat output level
Ambient temperature
Task temperature