Air Supply And Connections - DeWalt DWEHF1838K Guide D'utilisation

AIR SUPPLY AND CONNECTIONS

Do not use oxygen, combustible gases, or bottled gases as a power source for this tool as
tool may explode, possibly causing injury.
FITTINGS
Install a male plug on the tool which is free flowing and which will release air pressure from the tool when
disconnected from the supply source.
HOSES
Air hoses should have a minimum of 150 psig (10.6 kg/cm
maximum pressure that could be produced in the air system. The supply hose should contain a fitting that will
provide "quick disconnecting" from the male plug on the tool.
SUPPLY SOURCE
Use only clean regulated compressed air as a power source for this tool. NEVER USE OXYGEN, COMBUSTIBLE
GASES, OR BOTTLED GASES, AS A POWER SOURCE FOR THIS TOOL AS TOOL MAY EXPLODE.
REGULATOR
A pressure regulator with an operating pressure of 0 - 125 psig (0 - 8.8 kg/cm
pressure for safe operation of this tool. Do not connect this tool to air pressure which can potentially exceed 200
psig (14 kg/cm ) as tool may fracture or burst, possibly causing injury.
2
OPERATING PRESSURE
Do not exceed recommended maximum operating pressure as tool wear will be greatly increased. The air supply
must be capable of maintaining the operating pressure at the tool. Pressure drops in the air supply can reduce
the tool's driving power. Refer to "TOOL SPECIFICATIONS" for setting the correct operating pressure for the tool.
Quick Disconnect Plug
) working pressure rating or 150 percent of the
2
Quick Connect Plug
-6-
) is required to control the operating
2