Abicor Binzel 20G Mode D'emploi page 26

6 Putting into operation
6.1 Equipping the TIG welding torches
6.1.1 AUT-WIG 20G/400W
1
7
1 Gas nozzle
2 Gas diffuser
3 Torch body
Fig. 1 Equipping the 20G/400W
EN - 8
NOTE
• TIG welding torches may only be put into operation by trained
personnel.
CAUTION
Risk of injury
Puncture caused by sharpened electrode tip.
• Do not reach into the danger zone.
• Wear protective gloves.
2
4 Guide tube
5 Collet
6 Retaining nut
1 Unscrew retaining nut (6) from guide tube (4).
2 Insert collet (5) into guide tube (4) and secure it with the retaining nut (6).
3 Screw guide tube (4) into torch body (3).
4 Screw gas diffuser (2) into torch body (3).
5 Insert the tungsten electrode (7) into the torch body (3) from the front.
6 Screw gas nozzle (1) onto gas diffuser (2).
7 Set tungsten electrode (7) to the required length and fasten it to the guide
tube (4).
3
6
7
AUT-WIG
4
5
Tungsten electrode