Smartphone Pairing - Fermax F1436 Manuel De L'utilisateur

1.5.2 Smartphone pairing.

Connect monitor to home router and pair first smartphone
1. Select option "WiFi factory setting" to start the connection of the monitor to the home
router. This will reset any previous WiFi connection. It will also reset the pin code for the
connection that encrypts the connection.
2. Monitor will create an access point which SSID (UIDXXXXX) is indicated in this page.
Icon shows and AP.
3. iOS App and Android version 8.0 or higher: connect smartphone to the WIFI created
by the monitor (UIDXXXX).
Android App version lower than 8.0: connect to the building's WIFI.
4. Open the app «WAY-FI», press the "+" icon and select "New Device"
5. iOS app: enter SSID name of home WIFI and password and press Next.
Android app: select the right UID of the monitor and press Next, select the home WIFI
from the list and enter password, press Next.
6. Wait for the monitor to configure successfully (it takes 120").
7. You can set the home name ("device"). Password can be modified afterwards.
8. Confirm that monitor is successfully linked to the router through the WIFI settings menu.
It must indicate the SSID name* and signal strength.
*name is trunked to 10 characters. Letters are shown in lower case and special symbols
are shown as '*'.
9. You can check connection quality by touching the device rectangle.
IMPORTANT Remark:
The first time you connect, for security reasons, you will be asked to change the
•
password.
12