AFi LISA Série Manuel De Maintenance page 65

The lid axis is located in the back of the machine
(fig 1). Be sure to have enough space around the
machine so as to work in good safety conditions
Before starting, open the lid, switch off the
centrifuge and unplug power cable
CAUTION: THE FOLLOWING
OPERATIONS MUST BE PERFORMED
BY A QUALIFIED TECHNICIAN
Step 1: Remove screws each side of the
axis then insert the axis with hammer and use
punch to finish the operation. Limit is the new
axis's marking line
Step 2: Extract the old axis then apply
thread lock on screws (each side of axis) and
tighten very carefully
Notice Originale - Rev.1.4
PROCEDURE AP2.008
LID AXIS REPLACEMENT
Manuel Maintenance – Lisa / Loreena
Fig 1
Axis extractioN
1/ 2