To Clean The Product - Husqvarna PG 400 Petrol Manuel D'utilisation

Maintenance
Clean the air filter.
Replace the air filter.
Examine the spark plug.
Replace the spark plug.

To clean the product

• Always clean all the equipment after use.
• Do not use a high-pressure washer to clean the
product.
• Keep the air openings clean and clear to make sure
that the product always has sufficiently cool
temperature.
Note: Do not use compressed air to clean below the
grinding head.
To do a check of the oil level
CAUTION: To operate the product with a low
oil level can cause damage to the engine.
1. Stop the engine. Refer to
page 13 .
2. Put the product on level ground.
3. Remove the oil tank cap.
4. Clean the oil from the dipstick that is attached to the
oil tank cap.
5. Put the dipstick in the oil tank. Do not tighten it.
6. Pull the dipstick out and read the oil level.
A
B
C
a) If the oil level is low (A), fill with engine oil and do
a check of the oil level again. For correct oil type,
Technical data on page 18 .
refer to
1
Clean more frequently if the product is used in dirty areas.
14
Each use
To stop the product on
First month Each 3
or after 20 months or
h 50 h
1
X
b) If the oil level is high (C), do not fill with more
engine oil. The oil level must be between (A) and
(B).
7. Tighten the oil tank cap correctly before you start the
engine.
To replace engine oil
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING: Engine oil is very hot directly
after the engine stops. Let the engine
become cool before you drain the engine oil.
If you spill engine oil on your skin, clean with
soap and water.
1. Put the product on level ground.
2. Put a container below the oil drain plug.
3. Remove the oil tank cap, the oil drain plug and the
washer.
Note: Discard the washer.
4. Tilt the product and let the oil run out into the
container.
5. Put the engine in level position and fill the oil tank
with recommended oil. Refer to
oil level on page 14 and Technical data on page 18 .
6. Install a new washer, the oil drain plug and tighten
the oil tank cap.
To examine the air filter
CAUTION: Do not use a product without an
air filter or with a damaged air filter.
Each 6 Each year
months or or 300 h
100 h
X
X
X
To do a check of the
883 - 002 - 10.09.2020