Seca 984 Mode D'emploi Et Garantie page 28

– Once the correct tare value is set, press
the FUNC key again. The pre-Tare
function is now activated.
– Now gradually push all four measuring
feet under the bed castors to lift the
bed.
– Read the weighing result off the digital
display.
– To return to normal weighing mode,
press the FUNC key.
– To switch off the scale, press the
START key again.
Moving and storing the scale
– Switch off the scale.
– Unlock the actuating lever of the meas-
uring foot by pressing down the round
knob and folding out the lever.
– Raise the actuating lever to lower the
castor.
– Pull the measuring foot out to the side,
wind up the cable and place the meas-
uring foot in one of the compartments
of the equipment trolley.
– Proceed in exactly the same way to re-
move the remaining three measuring
feet and store them on the trolley.
– Disconnect the mains plug from the
socket and likewise store the mains unit
on the equipment trolley.
– Release the brakes on the equipment
trolley.
You can now move the bed scale to its
next point of use or "park" it somewhere
out of the way until it is required again.
28