Trial Operation; Connecting The Power Plug - Invacare Aquatec Pure Bidet Manuel D'utilisation

1. Remove the push plate from the flush-mounted housing.
2. Remove the rear cover plate to obtain a direct perspective on
the connection.
3. Turn the water tap off.
Remove connecting sleeve D and replace by T-piece E.
4.
Connect T-piece with PVC Flexible hose C.
5.
Connect PVC Flexible hose with tube A using nut B.
6.
Connect tube A with pure bidet.
7.
8. Turn the water tap on.
IMPORTANT!
– Check the connection for leaks and re-fit if
necessary.
9. Cut-out inner cover plate F, mounting plate G and push plate H
according to the figure above taking into account the indicated
dimensions [mm].
10. Re-attach the inner cover plate and the mounting plate inside the
flush-mounted housing.
11. Close flush-mounted housing with the push plate.
Following parts are needed for the assembly of the
flush-mounted water flow but are not included in the scope
of delivery:
• Tube A
• Nut B
Available at your specialised dealer.
1557407-E

4.3 Trial operation

Leakage test
A
1. Open the shut off valve A completely by turning
counterclockwise.
2. Check for any water leakage on the connection hoses, tighten if
necessary.

Connecting the power plug

1. Read and follow the safety information regarding electrical safety,
® 2.1 Safety information, page 6 .
2. Connect power plug to a suitable power source.
Setup
13