Figure 3.13: Oscar Interface Screen Saver Dialog Box - Avocent DSR2035 Guide D'installation Et D'utilisation

38
DSR2035/8035 Switch Installer/User Guide
3. Select Scan Enable in the Commands dialog box.
4. Click X to close the Commands dialog box.
NOTE: Scanning will begin as soon as the Scan Enable button is selected.
To cancel Scan mode:
Select a target device if the OSCAR interface is open.
-or-
Move the mouse or press any key on the keyboard if the OSCAR interface is not open. Scanning
will stop at the currently selected target device.
-or-
If the OSCAR interface is not open, press
a. Click Commands to open the Commands dialog box shown in Figure 3.12 on page 37.
b. Clear Scan Enable.
Setting local port Screen Saver options
Use the Screen Saver dialog box to manage the screen saver inactivity time and test the Screen
Saver mode on the local port. If security has been enabled in the DSView software, after the
specified Inactivity Time elapses, the local port locks and remains locked until you press any key or
move the mouse. You will then need to log in to continue.
To access the OSCAR interface Screen Saver dialog box:
1. If the OSCAR interface is not open, press
2. Click Setup - Screen Saver to open the Screen Saver dialog box as shown in Figure 3.13.

Figure 3.13: OSCAR Interface Screen Saver Dialog Box

The Main dialog box will appear.
Print Screen.
to open the Main dialog box.
Print Screen