Avocent DSR2035 Guide D'installation Et D'utilisation page 27

3. Set the Acceleration slider to the center position.
4. (Optional) Select the desired Mouse buttons option and set the Threshold slider to the
desired position.
5. Click OK to save your settings and to close the Control Center dialog box.
6. Resynchronize the mouse in the software remote session window for the Avocent management
software you are using.
• If you are using DSView software version 2.x or earlier, click Mouse Align.
• If you are using DSView software version 3.0 or later, click Align Local Cursor.
• If you are using the AVWorks software, click Screen Refresh.
The mouse resynchronizes and should work properly.
To adjust the mouse speed and pointer settings for Red Hat LINUX 8.0 and
later drivers:
1. Click the Red Hat icon.
2. Select Preferences - Mouse to open the Mouse Preferences dialog box.
3. Click the Motion tab.
4. Set the Acceleration slider slightly left of the center position.
NOTE: The sliders in Red Hat LINUX versions 8 and above do not contain numbers or tick marks. Proper
alignment may be achieved only by trial and error.
5. (Optional) Set the Sensitivity and Threshold sliders to the desired positions.
6. Click Close to save your settings and to close the Mouse Preferences dialog box.
7. Resynchronize the mouse in the software remote session window for the Avocent management
software you are using.
• If you are using DSView software version 2.x or earlier, click Mouse Align.
• If you are using DSView software version 3.0 or later, click Align Local Cursor.
• If you are using the AVWorks software, click Screen Refresh.
8. Test the mouse motion in the Video Viewer window.
9. If necessary, repeat steps 4 to 8 until the mouse is properly aligned.
To adjust the mouse speed and pointer settings for Red Hat Enterprise
LINUX drivers:
There are two ways to open the Mouse dialog box:
• To open the Mouse dialog box using a menu, go to step 1.
• To open the Mouse dialog box using icons, go to 4.
1. Click the Main Menu icon.
2. Select Programs - Settings - Peripherals - Mouse to open the Mouse dialog box.
3. Go to step 8 on page 16.
Chapter 2: Installation
15