Troubleshooting - Ridgid At161000 Manuel De L'opérateur

b. With the workpiece contact not engaged on the workpiece, point the tool down
and away in a safe direction and pull the trigger several times. Hold the trigger in
this position for a minimum of 5 seconds. The tool must not actuate.
c. Press the workpiece contact firmly against the workpiece and pull the trigger.
The tool must actuate.
d. With the workpiece contact still depressed, release the trigger. The driver must
return to its up position.
• Select the contact actuation mode (
• Begin inspection:
a. With the workpiece contact not engaged on the workpiece, point the tool down and
away in a safe direction. Pull the trigger. The tool must not actuate.
b. Fully depress the trigger and push the workpiece contact against a workpiece.
The tool must actuate.
• Disconnect the air supply from the tool.
• If the tool successfully meets all the requirements in this checklist, it is ready for use.
Set the trigger on the tool to operate in the manner that best fits your application.
Load the proper fasteners for the desired application.
• Set the depth of drive according to the Drive Depth Adjustment section in this manual.
Repeat this checklist before using the tool each day, or if the tool is dropped or
damaged in any way.

TROUBLESHOOTING

PROBLEM
Air leak near 1. Loose screws
the top of the
2. Worn or damaged O-rings
tool or in the
trigger area
1. Loose screws
Air leak near
the bottom
2. Worn or damaged O-rings or
of the tool
1. Inadequate air supply
2. Inadequate lubrication;
Tool does
nothing or
operates
sluggishly
3. Worn or damaged O-rings or
1. Incorrect fasteners
Tool jams
frequently
2. Damaged fasteners
3. Loose magazine
4. Dirty magazine
5. Worn or damaged driver
This product has a 90-Day Satisfaction Guarantee Policy,
For Warranty and Policy details, please go to REGISTER.RIDGIDAIR.COM
POSSIBLE CAUSE
or seals
bumper
Possible debris or buildup
slowing delivery of air through
the tool
bumper
as well as a Three-year Limited Warranty.
or call (toll free) 1 (866) 874-3443.
).
CORRECTIVE ACTION
1. Tighten screws
2. Install Overhaul Kit
1. Tighten screws
2. Install Overhaul Kit
1. Verify adequate air supply
2. Lubricate tool
3. Install Overhaul Kit
1. Verify that fasteners are the correct
size
2. Replace fasteners
3. Tighten screws
4. Clean magazine
5. Install Driver Maintenance Kit
16 – English