RIDGID AT161000 Manuel De L'opérateur page 13

OPERATION
USING THE SELECTABLE TRIGGER
WARNING:
Never wedge or hold back the
workpiece contact mechanism during operation of the
tool. Doing so could result in possible serious injury.
This tool is shipped from the factory with a selectable
trigger set in the Single Sequential Actuation mode.
The selectable trigger can also be set for Contact
Actuation mode.
SINGLE SEQUENTIAL ACTUATION MODE
Single sequential actuation provides the most
accurate nail placement.
•
Disconnect the tool from the air supply and
remove nailsfrom the tool.
•
Depress the actuation mode button.
•
Rotate the actuation mode selector to position (
•
Release the actuation mode button.
NOTE:
The actuation mode selector is spring loaded and held in
position by locking tab to prevent movement during operation.
WARNING:
The tool will not function properly if the selector
is not securely seated in either position (
make sure the selector is seated properly to avoid an
unexpected nail discharge and possible serious personal injury.
•
Reconnect the tool to the air supply and reload the
toolwith nails.
•
Grip the tool firmly to maintain control. Position
theworkpiece contact onto the work surface.
•
Push the tool against the work surface to depress theworkpiece contact.
•
Squeeze the trigger to drive a nail.
•
Allow the tool to recoil away from the work surface as thenail is driven.
•
Always remove your finger from the trigger when thedesired number of nails has
been driven.
CONTACT ACTUATION MODE
Contact actuation allows very fast repetitive nail placement.
•
Disconnect the tool from the air supply and remove nailsfrom the tool.
•
Depress the actuation mode button.
•
Rotate the actuation mode selector to Position (
•
Release the actuation mode button.
NOTE:
The actuation mode selector is spring loaded and held in position by locking
tab to prevent movement during operation.
•
Reconnect the tool to the air supply and reload the toolwith nails.
•
Grip the tool firmly to maintain control.
•
Squeeze and hold the trigger. Push the tool against thework surface to depress the
workpiece contact and drivea nail.
•
Allow the tool to recoil away from the work surface as thenail is driven.
•
Always remove your finger from the trigger when thedesired number of nails has
been driven.
NOTE:
In Contact Actuation Mode, the tool may also be operated by depressing the
workpiece contact against the surface and squeezing the trigger.
WARNING:
During normal use the tool will recoil immediately after driving a nail. This is
a normal function of the tool. Do not attempt to prevent the recoil by holding the nailer
against the work. Restriction to the recoil can result in a second nail being driven from the
nailer. Grip the handle firmly, let the tool do the work, and do not place second hand on top
of tool or near exhaust at any time. Failure to heed this warning can result in serious
personal injury.
).
) or ( ). Always
).
13 – English
O
B
K
H