REBER 10900 N Notice D'utilisation Et Entretien page 18

TOMATO SQUEEZER USE
This appliance is intended for household use only and limited quantity production. Assemble the pin with the
spring carefully following the assembly diagram; the spring must always be installed between the pin and the
propeller.
This appliance can squeeze both cooked or raw tomatoes.
The different qualities, the level and type of ripeness impact on the quantity of residual humidity in tomatoes
and, as a result, on appliance functioning and the end result; a biological product is always different season after
season.
If the tomato is cooked, leave it to cool slightly and insert it in the machine at a temperature under 50°, if raw, cut
into adequately sized pieces so they can fall into the neck of the casing without having to press them.
You are always advised to leave the tomatoes to drain (both cooked and raw) to remove plant water; this
procedure will avoid overly moist peel exiting and the risk of liquid leaking from the rear of the body.
The propeller was designed to obtain the best pressing if left to work without forcing; insert the tomato in the
funnel, allow it to fall into the casing with the pestle without pressing and leave the machine work without
forcing it. The propeller will empty autonomously, the pressed tomato will be correctly consistent, and you can
avoid excessively wet peel exiting (a second pressing can however take place if the tomatoes are very moist)
Pressing the tomato with the pestle when the propeller is already full of tomato can cause the liquid to leak from
the rear of the body, damaging the reducer: leaving the propeller to drain autonomously will avoid this problem.
If the tomato is too hot, and/or if you force it using the pestle when the propeller/filter system is full, you risk
clogging the system and damaging the filter cone and the body.
For dimension related reasons, it is partially dismantled in the packaging; you need to insert the towing pin with
the spring in the hole of the body (9), insert the propeller (10) in the body by inserting it on the towing pin, then
place the filter cone (11) over the propeller pressing it and rotating it in an anti-clockwise direction to fit the ears
of the ring nut in the specific grooves in the body.
Screw the funnel (8) onto the threaded neck and attach the drip pan (12) to the filter cone and the body using the
specific clips. The machine is then ready for use; it is strictly forbidden to operate the appliance dry (without
tomatoes).
When the work is complete, turn the power switch off (-0-) and disconnect the device from the power supply.
Unscrew the funnel (8), remove the drip pan (12), turn the filter cone (11) in a clockwise direction to remove the
propeller (10) and the towing pin with the spring. Remove the body (9) from the cover of the reducer (6), then
wash and carefully dry all the parts that have come in contact with food.