Analgesic And Decontracting Treatments - I-Tech Mio-Sonic Mode D'emploi

2. Put a good
treated. The gel is an important factor in order to guarantee a
right combination between the treated zone and the
ultrasound head so finally the therapy efficacy.
3. Move the on ON/OFF switch on ON position: PWR led and L
(low intensity) led will be switched on.
4. Put the ultrasound head on the area to be treated.
5. Select the intensity using the button MODE: middle intensity
led (M) and high intensity led (H) will light up sequentially.
6. Select the treatment time using the button TIME: 5-10-15 leds
will light up sequentially and the device will start to work.
ATTENTION: in ultrasound treatment we recommend an
adjusted intensity equal to M. If you use intensities equal to H
pay attention to keep ultrasound head in continuous movement.
Intensity equal to L corresponds to 0,7 W/cm
2
0,95 W/cm and H corresponds to 1,2 W/cm
ATTENTION: the device is equipped with a right combination
detector between the ultrasound head and patient skin in order
to guarantee patient safety. In case of wrong combination the
treatment time led starts flashing.
ATTENTION: it's important to keep in continuous movement
ultrasound head on the treated area during the therapy with
slow and circular or vertical (at least of 7-8 cm) movements. It's
forbidden to keep ultrasound head fixed in a point during the
treatment.

Analgesic and decontracting treatments

In the imagines pain zones are illustrated by the red color and
trigger points by the blue color.
Make reference to the table figures at the end of user manual
(pp 85-92) in order to get details and suggestions about
treatable pathologies.
Pain zones could be different from trigger points as it's illustrated in
the figures.
IACER Srl
quantity of ultrasound gel on the area to be
34 di 96
2
, M corresponds to
2
.
MNPG63 Rev. 00 del 24/02/11