Cutting Warped Material - Ridgid R41121 Manuel De L'opérateur

OPERATION
SLIDING
MITER FENCE
FENCE
SCREW
VIEW OF SAW FROM FRONT WITH FENCES
Downloaded from www.Manualslib.com
FACING FORWARD
manuals search engine

CUTTING WARPED MATERIAL

See Figures 41 - 42.
When cutting warped material, always make sure it is posi-
tioned on the miter table with the convex side against the
fence as shown in figure 42.
If the warped material is positioned the wrong way as shown
in figure 41, it will pinch the blade near the completion of
the cut.
WARNING:
To avoid a kickback and to avoid serious personal
injury, never position the concave edge of bowed
or warped material against the fence.
Fig. 40
29 - English
WRONG
Fig. 41
Fig. 42
RIGHT