RIDGID R41121 Manuel De L'opérateur page 18

ASSEMBLY
 Remove the sliding miter fences by pulling them up and
away from the miter table.
 Using the supplied hex wrench, loosen the socket
head screws that secure the fence to the miter table.
See figure 15.
 Rotate the fence left or right until the saw blade is parallel
with the square.
 Retighten the screws securely. Check blade squareness
to fence and readjust if necessary.
 Replace the sliding miter fences.
Your saw has several scale indicators. After squaring adjust-
ments have been made, it may be necessary to loosen the
indicator screws and reset them to zero. See Figures 19 - 20.
BLADE
SLIDING
MITER
FENCE
VIEW OF BLADE NOT SQUARE WITH FENCE,
ADJUSTMENTS ARE REQUIRED
Downloaded from www.Manualslib.com
SQUARE
MITER
TABLE
manuals search engine
INDICATOR
SCREW
MITER
SCALE
SCALE
INDICATOR
BEVEL
SCALE
Fig. 18
18 - English
SCALE
INDICATOR
Fig. 19
SCALE
INDICATOR
INDICATOR
SCREW
Fig. 20