ResMed AirTouch N30i Guide D'utilisation page 7

1. Pull the cushion from the frame.
2. Gently peel the cushion away and slide the vent out.
3. Undo the fastening tabs on the headgear strap and pull it from the
frame.
4. Squeeze the side buttons on the elbow and detach from the frame.
Note:
• The QuietAir or multi-hole vent can be removed to allow inspection of
the vent holes.
• After detaching the headgear, close the fastening tabs to prevent it
from damaging the fabric sleeves when handling.
Cleaning your mask at home
If there is any visible deterioration of a mask component (cracking,
crazing, tears etc.) the component should be discarded and replaced.
Pilling and fraying of fabric components may occur and do not affect
performance of the mask.
Thoroughly clean the mask components as follows:
After each use: Cushion, QuietAir vent, Multi-hole vent
Weekly: Headgear, frame and elbow
1. Soak the components in warm water with a mild liquid detergent.
Ensure that there are no air bubbles while soaking.
2. Hand wash the components with a soft, non-metallic bristle brush (eg,
soft bristle toothbrush). Pay particular attention to the vent holes. For
the AirTouch N30i cushion, hand wash only without a bristle brush.
3. Thoroughly rinse the components under running water. If the sleeve
on the frame becomes twisted, it can be repositioned when wet.
4. Squeeze the fabric components with a clean towel to remove excess
water. Shake the QuietAir vent to remove any excess water.
6