Assembling The Single Blade Paddle; Disassembling The Product - Mistral 100324202 Instructions De Montage, De Fonctionnement Et De Sécurité

Insert the rear part of the US fin
box, and slide it backwards. Insert the front part
of the US fin into the fin box and slide the
12
US fin forwards until the hole in the fin is
12
positioned over the hole in the metal plate
Insert the screw into the hole in the fin and
12b
screw it into place together with the metal plate
to secure the US fin
12a
Note: Always ensure that the fin is facing to-
wards you when carrying the board
particularly careful not to injure others with the
board in windy conditions.
1
Assembling the single blade
paddle (see Fig. F)
Loosen the locking lever
bar .
4
Insert the paddle shaft
bar .
4
Extend the paddle shaft
Note: For information about the recommended
paddle length, please see chapter "Adjusting
the paddle length".
Press in the locking lever
bar to lock the paddle shaft
4
Insert the paddle blade
the extension bar . Ensure the locking pin is
4
inserted all the way into the pinhole on the
paddle blade . You must hear the pin on the
2
extension bar click into place when it locks
4
into the pinhole of the paddle blade

Disassembling the product

Select a clean, even surface with adequate
space to disassemble the product.
Disassembly requires the following steps:
· Removing the US fin
12
· Releasing air from the board
· Rolling up the board
· Disassembling the paddle into the individual
parts
Note: Remove the US fin
air from the board .
1
into the fin
12
.
12a
.
12
. Be
1
on the extension
4a
into the extension
3
to the desired length.
3
on the extension
4a
.
3
in the opening on
2
.
2
1
1
before releasing
12
Removing the US fin:
To remove the US fin
in the chapter "Installing the US fin" in reverse
order.
Disassembling the paddle:
To disassemble the paddle, follow the instruc-
tions in the chapter "Assembling the single
blade paddle" in reverse order.
Releasing air (see Fig. E and G):
Place the dry board
open the two valves
needle down whilst turning it clockwise.
1b
Only push the valve needle
so that air can escape slowly.
Release the air.
You can alternatively use the air pump
fold the board as flat as possible by attach-
1
ing the hose backwards on the air pump
15
(Deflate). Connect the hose
13
the valves . The valve head must be down.
1a
Turn the valve head to the right, and pump to
extract the remaining air from the board
until it is completely flat.
Then turn the valve head anticlockwise so that
it comes up and out.
Now place the board
Then fold the board
nose over the tail.
Then fold the tail with the nose once more.
Do not fold the board
outside edges of the fin box. This will
cause excessive tension in the board
.
1
Now fold the opposite side up to about the
middle.
Then fold the board
posite side.
Use the strap to tie down the board
, follow the instructions
12
flat on the ground and
1
by pushing the valve
1a
down slightly,
1b
to
13
to one of
15
1
flat on the ground.
1
once and place the
1
along the
1
once more on the op-
1
.
1
GB/IE 25