Direct Wire Connection - Whirlpool W11555816A Guide D'utilisation Et D'entretien

3. Connect remaining wires
Connect remaining wires under outer terminal block screws.
Tighten screws. Insert tab of terminal block cover into slot of
dryer rear panel. Secure cover with hold-down screw. Now, go to
"Venting Requirements."

Direct Wire Connection

Power Supply Cord Strain Relief:
1. Attach direct wire strain relief
Unscrew the removable conduit connector (A) and any screws
from a 3/4" (19 mm) UL listed strain relief (UL marking on strain
relief). Put the threaded section of the strain relief through the
hole below the terminal block opening (B). Reaching inside the
terminal block opening, screw the removable conduit connector
(A) onto the strain relief threads (C) and tighten securely.
2. Attach direct wire cable to strain relief
Put direct wire cable through the strain relief. The strain relief
should have a tight fit with the dryer cabinet and be in a
horizontal position. Tighten strain relief screw against the direct
wire cable.
For 4-wire Direct Wire Connection, continue to step 3.
For 4-wire Direct Wire Connection, continue
to step 3.
For 3-wire Direct Wire Connection, continue
to step 3.
4-Wire Direct Wire Connection
IMPORTANT: A 4-wire connection is required for mobile homes
and where local codes do not permit 3-wire connections.
Direct wire cable must have 5 ft (1.52 m) of extra length so dryer
may be moved if needed.
Strip 5" (127 mm) of outer covering from end of cable, leaving
bare ground wire at 5" (127 mm). Cut 11 /2" (38 mm) from
remaining 3 wires. Strip insulation back 1" (25 mm). Shape ends
of wires into hooks.
2. Prepare to connect neutral bond wire and
neutral wire
Remove center terminal block screw (B). Remove neutral bond
wire (E) from green external bond conductor screw (A).
4-wire direct wire connection: Go to
"4-Wire Direct Wire Connection."
3-wire direct wire connection: Go to
"3-Wire Direct Wire Connection."
21