Whirlpool W11555816A Guide D'utilisation Et D'entretien page 20

4. Connect neutral bond wire and neutral wire
Connect neutral bond wire (E) and neutral wire (white or center)
(C) of power supply cord under center terminal block screw (B).
Tighten screw.
5. Connect ground wire
Connect ground wire (F) (green or bare) of power supply cord
under green external ground conductor screw (A). Tighten screw.
6. Connect remaining wires
Connect remaining wires under outer terminal block screws.
Tighten screws. Insert tab of terminal block cover into slot of
dryer rear panel. Secure cover with hold-down screw. Now, go to
"Venting Requirements."
20
3-Wire Power Supply Connection
IMPORTANT: Use where local codes permit connecting
cabinet-ground conductor to neutral wire.
A. 3-wire receptacle
(NEMA type 14-30R)
B. 3-prong plug
C. Neutral prong
D. Spade terminals with
upturned ends
1. Remove center screw
Remove center terminal block screw (B).
2. Connect neutral wire
Connect neutral wire (white or center) (C) of power supply cord
under center terminal block screw (B). Tighten screw.
E. 3/4" (19 mm) UL listed
strain relief
F. Ring terminals
G. Neutral (white or center
wire)