Whirlpool W11555816A Guide D'utilisation Et D'entretien page 13

7.
Select wash temperature
Select the desired wash temperature by turning the Wash Temp
knob to the desired setting. All rinses are cold.
NOTE: Always read and follow fabric care label instructions to
avoid damage to your garments.
Wash Temp
Hot
Some cold water is added
to save energy. This will be
cooler than your hot water
heater setting.
Warm
Some cold water will be
added, so this will be cooler
than what your previous
washer provided.
Cool
Some warm water may
be added to assist in
soil removal and to help
dissolve detergents. Cool is
slightly warmer than cold.
Cold
This is the temperature from
your faucet. Warm water may
be added to assist in soil
removal and to help dissolve
detergents.
Tap Cold
This is the temperature from
your faucet.
Suggested Fabrics
Whites and pastels, Durable
garments, Heavy soils
Bright colors, Moderate to
light soils
Colors that bleed or fade,
Light soils
Dark colors that bleed or fade,
Light soils
Dark colors that bleed or fade,
Light soils
8.
Select fabric softener (if desired)
Set this knob to Yes when adding fabric softener to the fabric
softener dispenser.
9.
Press START/PAUSE to begin
wash cycle
Press the START/PAUSE button to start the wash cycle. When
the cycle has finished, the Done indicator will light. Promptly
remove garments after cycle has completed to avoid odor,
reduce wrinkling, and prevent rusting of metal hooks, zippers,
and snaps.
Adding garment(s)
If you need to open the lid to add one or two missed garments:
Press the START/PAUSE button. The lid will unlock once the
washer movement has stopped. This may take several minutes
if the load was spinning at high speed. Add garments, close lid,
and press the START/PAUSE button again to restart the cycle.
NOTE: Washer will not fill with the lid open.
IMPORTANT: If lid is left open for more than 10 minutes, the
water will pump out automatically.
Manual Soak
If you would like to manually soak your garments at any
time during the wash portion of the cycle, press the START/
PAUSE button and leave the lid closed. Once your desired soak
time has elapsed, press the START/PAUSE button again to
continue the cycle. As long as the lid remains closed, your soak
time can be longer than 10 minutes. However, if the lid is opened
during the soak and remains open for more than 10 minutes, the
water will pump out automatically.
13