Machine Specifications; Technical Data; Noise Emission; Contents Of Delivery - Jet JWP-12 Mode D'emploi

Sawdust and noise can be health
hazards. Be sure to wear personal
protection gear such as safety
goggles and ear protection. Use a
suitable dust exhaust system.
The use of incorrect mains supply or
a damaged power cord can lead to
injuries caused by electricity.

4. Machine specifications

4.1 Technical data

Planing width
Planing thickness
Depth of cut
Number of knives
Cutterhead diameter
No-load speed n
o
Cuts per minute
Cutter knife length
Cutter knife width
Cutter knife thickness
Feed rate
Dust port diameter
Weight
Mains 230V ~1L/N/PE 50-60Hz
Motor input power
Reference current
Extension cord H05W-F 3G1mm²
Installation fuse protection

4.2 Noise emission

(Inspection tolerance 4 dB)
Acoustic power level
(according to EN 3746):
Idling LwA 101,5 dB(A)
Acoustic pressure level
(according to EN 11202):
Idling LpA 88,7 dB(A)
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
This information is intended to allow
the user to make a better estimation
of the hazards and risks involved.
4.3 Content of delivery
Planer
Dust chute 100mm
Thickness crank
Knife setting gauge
4 Rubber feet
Assembly kit
Operating manual
Spare parts list

4.4 Description of machine

max 318 mm
6 to 153 mm
max. 2,5 mm
2
48 mm
9000 rpm
18000
319mm
18mm
A....ON/OFF Switch
3mm
B....Overload cut-off
7 m/min
C....Transport rollers
100mm
D....Motor brushes
30 kg
E....Thickness crank
F....Carrying handles
1800W G....Thickness scale
8 A
H....Mounting holes
I.....Support infeed roller
16A

5. Transport and start up

5.1 Transport and installation

The machine is designed to operate
in closed rooms and must be placed
stable on firm and levelled ground.
The machine can be bolted down if
required.
Fold the infeed and outfeed rollers
up when the planer is not in use and
during storing.
Wrap the power cord around the
hangers under the infeed table(Fig2)
Fig 1
5
Fig 2
For packing reasons the machine is
not completely assembled.

5.2 Assembly

If you notice any transport damage
while unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces
with a mild solvent.
Install rubber feet (J) and Thickness
crank (B).
Fig 3

5.3 Mains connection

Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine
licence plate.
The mains connection must have a
16 A surge-proof fuse.