Dmx Mode; Slave Mode - Cameo CLMPAR3 Manuel D'utilisation

IR ACTIVE
In "IR ACTIVE" mode, the multi-PAR lighting system can be controlled solely via the included infrared remote control. To control the lighting system
in this mode, press the MODE button repeatedly until "IR ACTIVE" appears in the display. Then press ENTER. The cursor appears in the bottom line of
the display. Use the UP and DOWN buttons to select "ON". Confirm the input with ENTER.
If you later want to control the system in DMX mode, by foot pedal or in a stand-alone mode, set the "IR ACTIVE" mode to "OFF" again in the same
manner.
MASTER DIMMER
The "MASTER DIMMER" lets you set the basic brightness of the lighting system in the stand-alone modes and when controlling it by foot pedal. Press
the MODE button repeatedly until "MASTER DIMMER" appears in the display. Then press ENTER. The cursor appears in the bottom line of the display.
Use the UP and DOWN buttons to set the desired basic brightness (00 - 99) and confirm the input with ENTER.
DIMMER
In "DIMMER" mode, each of the four individual lights can be set to an individual static colour through colour mixing. Press the MODE button repeat-
edly until "DIMMER" appears in the display. Then press ENTER and use the UP and DOWN buttons to select the desired light 1 - 4 and confirm with
ENTER. Now the display shows the brightness values of the individual colour LEDS (R = red, G = green, B = blue, and W = white) of the selected light
from 00 to 99. The cursor is the "R" field in the top line. Now use the UP and DOWN buttons to set the brightness of the red LED. Pressing ENTER
confirms the input and moves the cursor ahead to the "G" field for the green colour LEDs. Here, again use the UP and DOWN buttons to set the
brightness to the desired value. The same procedure also applies analogously for the blue (b) and white (w) LEDs.
After confirming the value for the white LEDs by pressing ENTER, "DIMMER" appears in the display again and you can select one of the four lights for
colour adjustment as described above.

DMX MODE

This menu item makes it possible to select both the DMX start address and the DMX mode in which the multi-PAR lighting system should operate.
Press the MODE button repeatedly until "DMX MODE" appears in the display. Then press ENTER. The cursor appears in the "ADDR:xxx" field. Use the
UP and DOWN buttons to select the DMX start address of the lighting system from 001 to 512. Confirm the input with ENTER. Simultaneously, the
cursor jumps ahead to the "CH:xx" field. There are 7 different DMX modes that can be selected using the UP and DOWN buttons. Confirm the input
with ENTER. The various DMX modes are explained on one of the following pages.

SLAVE MODE

If you want to control the LED multi-PAR lighting system either using the optional foot switch (CLMPARFOOT2) or have it controlled by a second
CLMPAR3 (master) in one of the stand-alone modes, the "SLAVE MODE" must be selected. Press the MODE button repeatedly until "SLAVE MODE"
appears in the display. The connection between the master and slave unit is made using a DMX cable, whereby the DMX output of the master unit
must be connected to the DMX input of the slave unit.
Note: The illumination of the LC display switches off automatically after approx. 1 minute of inactivity. Pressing any one of the 4 control buttons will
turn on the illumination of the LC display again.
19