Third Party Software - Canon imagePRESS C910 Guide Rapide

About This Manual
Screens
Screens of the touch panel display used in this
manual are those taken when the imagePRESS
C910 has the following optional equipment
attached to it:
Duplex Color Image Reader Unit-M
•
• Upright Control Panel-G
• Booklet Trimmer-F
Booklet Finisher-W PRO
•
Puncher Unit-BT
•
• Paper Folding Unit-J
• Document Insertion Unit-N
POD Deck Lite-C
•
Note that functions that cannot be used
depending on the model or options do not
appear on the touch panel display.
Illustrations
Illustrations used in this manual are those
displayed when the imagePRESS C910 has the
following optional equipment attached to it:
• Duplex Color Image Reader Unit-M
Upright Control Panel-G
•
• Copy Tray-R
If your machine is of the model dedicated to
printing only
The machine dedicated to printing only cannot
be used for any other functions than printing.
Although this Guide contains the descriptions
of the functions and operations for copying,
faxing, and scanning as well as printing, please
read only the necessary descriptions to use your
machine.
Trademarks
QR Code is a trademark of DENSO WAVE
INCORPORATED.
All brand names and product names appearing
on this manual are registered trademarks or
trademarks of their respective owners.

Third Party Software

This Canon product (the "PRODUCT") includes
third-party software modules. Use and
distribution of these software modules,
including any updates of such software
modules (collectively, the "SOFTWARE") are
subject to license conditions (1) through (9)
below.
(1) You agree that you will comply with any
applicable export control laws, restrictions
or regulations of the countries involved in
the event that this PRODUCT including the
SOFTWARE is shipped, transferred or
exported into any country.
(2) Rights holders of the SOFTWARE retain in all
respects the title, ownership and intellectual
property rights in and to the SOFTWARE.
Except as expressly provided herein, no
license or right, expressed or implied, is
hereby conveyed or granted by rights
holders of the SOFTWARE to you for any
intellectual property of rights holders of the
SOFTWARE.
(3) You may use the SOFTWARE solely for use
with the PRODUCT.
(4) You may not assign, sublicense, market,
distribute, or transfer the SOFTWARE to any
third party without prior written consent of
rights holders of the SOFTWARE.
(5) Notwithstanding the foregoing, you may
transfer the SOFTWARE only when (a) you
assign all of your rights to the PRODUCT and
all rights and obligations under the license
conditions to transferee and (b) such
transferee agrees to be bound by all these
conditions.
(6) You may not decompile, reverse engineer,
disassemble or otherwise reduce the code
of the SOFTWARE to human readable form.
(7) You may not modify, adapt, translate, rent,
lease or loan the SOFTWARE or create
derivative works based on the SOFTWARE.
(8) You are not entitled to remove or make
separate copies of the SOFTWARE from the
PRODUCT.
(9) The human-readable portion (the source
code) of the SOFTWARE is not licensed to
you.
Notwithstanding (1) through (9) above, the
PRODUCT includes third-party software
modules accompanying the other license
conditions, and these software modules are
subject to the other license conditions.
Please refer to the other license conditions of
third-party software modules described in
Appendix of Manual for the corresponding the
PRODUCT. This Manual is available at
http://canon.com/oip-manual.
By using the PRODUCT, you shall be deemed to
have agreed to all applicable license conditions.
If you do not agree to these license conditions,
please contact your service representative.
V_190919
Appendix
33