Access Doors - Briggs & Stratton 01810-0 Manuel D'installation Et De Mise En Service

Figure 3 — Location of Lifting Holes
To lift:
Insert
pipe
here
Installer-supplied pipe

Access Doors

The Home Standby Generator is equipped with an
enclosure that has four access doors (Figure 4).The doors
are named for a significant component located behind
them. Starting with the side that has the fuel connection
and proceeding clockwise, the doors are named:
Figure 4 — Enclosure Access Doors
Door Lock
Screw
30"
Briggs & Stratton Power Products Home Generator
Installation Manual
• Oil Service door
• Air Intake door
• Control Panel door
• Battery door
Each Home Standby Generator is equipped with three
identical keys.These keys fit the locks that secure the Oil
Service and Control Panel doors.
DO NOT operate the Home Standby Generator unless
the Oil Service and/or Control Panel doors are installed.
• Failure to install Oil Service and/or Control Panel doors while
To Remove an Access Door:
1.
NOTE: The key is retained in the lock when the locks are
open.
2.
3.
Exhaust
Fuel
Inlet
Door
Lock
Screw
42"
6
CAUTION
operating the Home Standby Generator will cause overheating.
Insert key into lock of access door you wish to
remove and turn one quarter turn clockwise.
Grasp door's lift handle and pull door upwards until
security pins are free of lower base.
With the security pins free, pull the lift handle outward
(away) from the unit while pulling the door down and
out of the upper door channel.The door will come
free of the generator enclosure.
Port
29"