Cleaning; Trouble Shooting; Corrective Action - FLORABEST FAT 18 B2 Traduction Du Mode D'emploi Original

Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!

Trouble shooting

Problem
Appliance won't
start
Intermittent opera-
tion
Much vibration
Loud noise
Bad trim
Possible cause
Battery ( 16) discharged
Battery ( 16) not in
On/Off switch ( 2) de-
fective
Motor defective
Internal loose contact
On/Off switch ( 2) de-
fective
Cutting insert ( 13) bro-
ken
Trimming assembly dirty
Motor defective
Cutting insert ( 13) bro-
ken
Trimming assembly dirty
Battery ( 16) not fully
charged
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or solvents.
You may otherwise irreparably dam-
age the appliance.
• After every trimming session, remove
grass and soil from the protective cover
and the trimming assembly.
• To thoroughly clean the trimming as-
sembly, remove the cutting insert
( 13) (see "Replacing the cutting
insert") and use a sharp knife to clean
the pin ( 24).

Corrective action

Recharge battery (
„Charging")
Insert battery (
Send in to Service Centre for repair
Send in to Service Centre for repair
Replace cutting insert (
„Cleaning and servicing")
Clean trimming assembly (see „Cleaning
and servicing")
Send in to Service Centre for repair
Replace cutting insert (
„Cleaning and servicing")
Clean trimming assembly (see „Cleaning
and servicing")
Recharge battery (
„Charging")
16) (see
16) (see „Operation")
13) (see
13) (see
16) (see
GB
53