Auto Pausing At The Beginning Of A Track - Sony MDS-DRE1 Mode D'emploi

Assigning Cue Points to Pads
z You can also erase cue points from pad memory using the
Setup Menu
1 Press STOP to stop playback.
2 Press EDIT/NO twice to display "Setup Menu".
3 Turn AMS to display "PAD Erase?", then push AMS.
"–Rehearsal–" blinks in the display and unit repeats a 3
second section starting from one of the cue points.
4 Turn AMS to select the cue point you want to erase.
5 Press AMS to erase the cue point.
"Complete!!" appears in the display, and the corresponding
pad indicator lights green.
Notes
• Only one cue point can be memorized per track. If you try to
assign another cue point to a pad that already has a memorized
cue point, "Over Mem?" appears in the display.
– To erase the previous cue point and assign the new one,
press ENTER/YES or the press the same pad again.
– To cancel the pad memory function, press EDIT/NO or
STOP.
• Cue points can only be assigned to pads which correspond to
their track numbers. For example, the cue point in track 2 can
only be assigned to pad 2 (BANK 1).
• To assign multiple cue points within a single song, first use the
Divide function (see page 28) to separate the song into different
tracks.
• After using a pad to start playback of a track, it is not possible
to use the 0/) buttons or the loop function. It is also not
possible to use the scrub dial during pause.
• The cue points are erased when the disc is ejected.
14 GB
Auto Pausing at the
Beginning of a Track
You can set the unit to pause automatically at the
beginning of each track (Auto Pause). You can also set the
unit to skip the blank space at the beginning of the track
and pause right before the sound begins (Auto Cue).
EDIT/NO
AUTO CUE
AUTO PAUSE
AUTO OFF
1
During stop, press AUTO PAUSE or AUTO CUE.
• Press AUTO PAUSE to light the "A.PAUSE"
indicator and set the unit to pause at the beginning
of each track.
• Press AUTO CUE to light the "A.CUE" indicator
and set the unit to skip the blank space at the
beginning of the track and pause right before the
sound begins.
2
Start playback.
Playback pauses either at the beginning of a track or
right before sound begins on the track.
To cancel AUTO PAUSE or AUTO CUE
Press AUTO OFF during stop.
z You can adjust the sound level Auto Cue defines as a blank
space and the timing of the pause that occurs once a blank
space has been detected.
1 Press STOP to stop playback.
2 Press EDIT/NO twice to display "Setup Menu".
3 Turn AMS to select one of the following parameters, then
press AMS.
- To change the sound level defining a blank space : AC (T)
- To change the timing of the pause : AC (O)
4 Turn AMS (or scrub dial) to set the value you desire, then
press AMS.
5 Press EDIT/NO to exit the Setup Menu.
The settings are retained even if the power is turned off.
The adjustable range of each parameter is as follows. The
numbers in parenthesis are the default values.
AC (T) : –72 dB to 0 dB in 2 dB steps (–50 dB)
AC (O) : –9s85f to +9s85f in 1f steps (0s00f)
When AC (O) is set to a negative (–) value, the unit
pauses by counting backwards from the point where
it detected the blank space.
To cancel without completing the settings, press EDIT/NO. This
returns the unit to the factory settings.
AMS
SINGLE
PLAY