LENCO DIR-70 BK Mode D'emploi page 8

Connecting to your router by scanning for available WiFi networks
If your router does not have a WPS Push Button option, then your radio can scan for
available WiFi networks.
1. When the Network Configuration screen is displayed, use the left hand
Navigation/Select rotary control to highlight 'YES' and press to Select.
2. 'Scanning for Wireless Network...' will be displayed, whilst your radio scans for available
WiFi networks.
3. After a few seconds a list of the Network Names (also know as SSIDs), for the WiFi
networks found during the scan will be displayed.
4. Use the Navigation/Select control to highlight the WiFi Network that the Radio should
connect to and press to Select.
Note: If your WiFi network is not listed, if may be because your router may be set not to
broadcast its Network Name or SSID. Please check your router settings; you can opt to
change your router to broadcast its network name so that it can be found during a WiFi
network scan by your Radio
Note: If your router is set to broadcast its Network name or SSID, but it has not been found,
please first try to scan again for WiFi networks. If your network is still not found, please try
moving your Radio closer to your router and then scan for WiFi networks again.
5. If your router requires a wireless password or an encryption key you will need to enter
this now to enable it to connect to your router. Some wireless routers already have an
encryption key or password that has been set by the manufacturer, this will be shown
either on the router itself or within the documentation provided with it.
6. 'Enter Password' will be displayed and a highlighted capital 'A' will be displayed on the
next line.
Note: To enter the wireless password or encryption key, use the left hand Navigation rotary
control to scroll through the letters and numbers
the next or previous letters. Do not press the left hand rotary control to Select, until you
have entered your complete password or key and checked that it is correct.
7. To enter the wireless password or encryption key into your radio, use the
Navigation/Select rotary control to display the first letter or number of your password.
and the or buttons to move to
8