Charging Mobile Devices With The Power Bank; Troubleshooting - SilverCrest SCP 10000B1 Instructions D'utilisation Et Consignes De Sécurité

3 LEDs light up = 75 %
4 LEDs light up = 100 %
This is approx percentage of power bank capacity but
not actual measurement.
Charging mobile devices
with the power bank
Use provided USB type A to micro USB cable with adapter
to USB type C
reliable supplier. Connect USB Type A port to USB output
of the power bank
3
And then connect USB type A to micro USB cable with
adapter to USB type C
micro USB port of the device to be charged. The charging
process will start automatically.
In case if the charging process does not begin immedi-
ately, press the ON / OFF switch
charging process. The current battery status of the power
bank is shown during the charging process by the
6
LED indicator
To end the charging process, separate the USB charging
cable from the mobile device and the power bank
The LED indicator
30 seconds. Or simply double click with ON / OFF
switch . The power bank
5
will switch off.

Troubleshooting

= Problem
= Cause
= Solution
28 GB/IE
or other charging cable purchased from
7
.
6
to the USB-C port or to the
7
.
1
will switch off after approx.
1
shortly to begin the
5
and LED indicator
6
.
6
1