Problems And Solutions - switel DC67 Série Mode D'emploi

In Case of Problems

Problems and solutions

Problems
No telephone calls possible
No connection to base station poss-
ible
Connection is disturbed or cut off
The system no longer responds
The batteries are empty within a
short time
The caller number display (CLIP
does not function
116
Solutions
− The telephone is not connected properly or is
defective. Only use the telephone connection
cable supplied.
− Test whether the telephone connection is in
order by using another telephone.
− The power adaptor plug is not plugged in or
there is a complete power failure.
− The rechargeable batteries are empty or de-
fective.
− The handset is too far from the base station.
− The wrong dialling mode is set; . Page 105.
− Check that the handset has been registered on
the base station with the correct PIN code;
. Page 105.
− The handset is too far from the base station.
− The base station is in an unsuitable location.
− Reset all the functions to their default settings;
. Page 104/105.
− Disconnect the power adapter plug briefly from
the power socket.
− The batteries are empty or defective.
− Place the handset in the base station properly.
Clean the contact surfaces on the handset and
base station with a soft, dry cloth.
− Place the handset in the base station for
16 hours.
1
) − The caller number display (CLIP) is a supple-
mentary service offered by your telephone net-
work provider. Contact your network provider
for further information.
− The caller has suppressed the transmission of
their phone number.