Operation; Connect The Probe; Switching The Instrument On / Off - TESTO 922 Mode D'emploi

5. Operation

28
5.
This chapter describes the steps that have to be executed
frequently when using the product.

5.1 Connect the probe

Plug-in probes
Plug-in probes must be connected before the measuring
instrument is switched on so that they are recognised by
the instrument.
Radio probes
A radio module (accessory part) is required for the use of
radio probes. The radio module must be connected before
the measuring instrument is switched on so that it is
recognised by the instrument.
Each radio probe has a probe ID (identification number).
This must be set in configuration mode.
5.2 Switching the instrument
info@Testo-Direct.com
Operation
Insert the connector of the probe into the probe
socket.
Radio probes may only be used in countries in which
they have been Type Approved (see application infor-
mation of the radio probe).
See the chapter
on / off
Switching t t he i i nstrument o o n:
www.
Press .
- Measurement view is opened: The current reading
is displayed, or ---- lights up if no reading is
available.
P
ERFORMING SETTINGS
Testo-Direct
.
1.888.475.5235
.com