AutoAqua Smart AWC Duo SAWC-400P Mode D'emploi page 4

Installation
1. AWC
(Auto Water Change)
i. Saltwater Aquarium
Step 1 :
Mount the blue sensor
( ) at normal water level S1
– ATO water level (with
the lower sensor
indicating the water
level) on the tank/sump
with the magnet.*
*Please avoid setting up the sensor in an area with micro bubbles
or direct light.
Step 3 :
Connect AWC drain
tube(pump
break*
Waste
Water
Waste
Water
Container
*Note : Place siphon break inside the tank/sump but above the
Air In :
Air In
Water Out :
Water Out
Water
Change
Volume
siphon
tubing holder).
water level.
Siphon break allows air in to break the siphon when the
pump turns off.
Water drops out of the hole are normal when the pump is on.
Tank/Sump
Arrow on siphon break
indicates water ow direction.
AWC
Drain
Pump
Tank/Sump
3
English
Step 2 :
Mount the green sensor
( ) at low water level S2
(with the top sensor
indicating the water
level) on the tank/sump
with the magnet.*
Step 4 :
Connect AWC
drain pump to
P2.