AutoAqua Smart AWC Duo SAWC-400P Mode D'emploi page 12

Auto Water Change Setting
1. AWC MANUAL Mode (One-Time AWC)
In this mode, users have to manually start the AWC process.
1). Touch
2). Touch
3). Touch
4). Touch
2. AWC AUTO Mode (Periodic AWC)
In this mode, Smart AWC Duo will do water changes periodically.
1). Touch
2). Touch
3). Touch
hour.*
4). Touch
to set it.
5). Touch
6). Touch
end, the next one starts immediately.
* If the display shows 00D : 00H, touching
** The display will go back to standby status without saving any
settings if there is no action for 10 seconds during the setting process.
*** P3 will not show and work in Freshwater mode.
Auto Water Change Process
1. ATO is turned off automatically during the process.
2. Old water in the tank/sump is pumped out until the water level reaches
the Low Level AWC Sensor.
3. New water is lled into the tank/sump until the water level reaches the
High Level AWC sensor.
4. ashes for 3minutes to balance the water level. It will ll
new water automatically if the water level drops.
5. When water change is done,
until the screen shows
and the or
again to save the setting.
to start the water change.
until the screen shows
and the "D" will ash. Touch
again and the "H" will ash. Touch
again and the
again to save the setting.
to start the countdown timer. As soon as it reaches the
.
will ash. Touch
.
or
or will ash. Touch
will go back to date setting.
will ash 5 times with 5 beeps.
11
English
or to set it.
to set the date.
or to set the
or