Safety; General Safety Instructions; Instructions, Standards And Regulations; Appliance Description - Stiebel Eltron SHP-A 220 Plus Utilisation Et Installation

iNSTAllATiON

Safety

iNSTAllATiON
7. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1

General safety instructions

We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
7.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
Take note of the appliance type plate and chapter "Specification".
8.

Appliance description

8.1

Standard delivery

Note
Accessories are located in the corners of the packaging.
Remove the accessories before disposing of the pack-
aging.
1
1 Corners of the packaging
The following are delivered with the appliance:
- Condensate drain bend
- For the "Cold water inlet" and "DHW outlet" connections: 2
insulated screw fittings comprising a flanged pipe, a gasket,
a union nut and an insulating sleeve
8.2

Required accessories

Various safety assemblies are available that are selected according
to supply pressure. These type-tested safety assemblies protect
the appliance against unacceptable excess pressure.
8.3

Additional accessories

– Condensate pump (if the condensate cannot be drained off with
a naturally occurring fall)
14 | SHP-A 220-300 Plus
9.

Preparation

9.1

Transport

CAUTION Injury
!
f Observe the weight of the appliance. f
f Use suitable transport aids (e.g. sack truck) and f
enough personnel for transportation.
Material losses
!
The appliance has a high centre of gravity and low over-
turning moment.
f Safeguard the appliance against falling over. f
f Only set the appliance down on an even base. f
Material losses
!
The appliance casing is not designed to withstand strong
forces. Incorrect handling can lead to material losses of
considerable extent.
f Observe the information on the packaging. f
Only remove the packaging shortly before the installation.
Where possible, do not unpack the appliance until it has arrived
in the installation room. For transport and handling leave the ap-
pliance in its packaging and on the pallet. This enables brief hori-
zontal transport and provides places to hold onto during transport.
If the appliance has to be unpacked before transportation, we
recommend using a sack truck. Pad the contact surfaces to avoid
damaging the appliance. Secure the appliance to the sack truck
using a strap. Pad between the strap and the appliance and avoid
overtightening the strap. Where stair wells are narrow, you can
carry the appliance by the handles on the sack truck and the foot
of the appliance.
Vehicular transport
Material losses
!
The appliance must generally be stored and transported
vertically.
The appliance may be transported horizontally for brief periods,
over a maximum distance of 160 km and on made-up roads.
Strong shocks are not permissible.
Material losses
!
If transported horizontally, the appliance must always be
laid on the shaded side of the box.
The appliance must not remain in a horizontal position
for more than 24 hours.
If the appliance was transported horizontally, leave it to
rest in a vertical position for at least one hour before
commissioning.
f Observe the information on the packaging. f
www.stiebel-eltron.com