Kit Contents; Special Precautions - Beta 1461/C11A Mode D'emploi

INSTRUCTIONS FOR USE
IMPORTANT:
Please always refer to the manufacturer's workshop manual to keep up-to-date about the related
exact procedures and data.
Applications:
RENAULT
Laguna III (07-), Megane, Scenic, Velsatis, Espace, Koleos, Trafi c.
NISSAN
Quashqui, X-Trail, Primastar.
VAUXHALL/OPEL
Vivaro.

Kit Contents:

Number
1
2
3
4
5
6
7
8
9

Special Precautions:

Always disconnect the earthing cable of the battery.
Turn neither the driving shaft nor the camshaft if the distribution chain has been removed.
Remove the glow plugs to make it easier for the engine to run.
Always run the engine in the normal direction of rotation (unless otherwise instructed).
Do not turn the engine while working on the camshaft or any other pinions.
If available: before disassembly, mark the position of the driving shaft position sensor.
Keep to all the recommended driving torques.
Valve Timing Procedures:
1. To remove/install the distribution chain, please take the following steps:
- Remove both the engine and the gearbox:
- Make sure that the engine is at the TDC of cylinder n°. 1.
- Make sure that the driving shaft locking pin has been fi tted in [1].
- Make sure that the groove [2] on the exhaust camshaft is in the horizontal position with the
large section on the groove turned upwards.
- Make sure that the timing notch on the induction camshaft gear [4] is in the 12 o'clock position
and aligned with the protuberance on the head cover [5].
- Make sure that the slot for the driving shaft key is in the 12 o'clock position [6].
- Lock the distribution chain tightener in a retracted position:
4
Item
P01 Camshaft locking/alignment tool
P04 Driving shaft locking pin
P02 Driving shaft pulley locking tool
Flywheel locking tool
P03
Two-piece camshaft alignment gear
P05 4-mm camshaft locking pin
P07 3-mm offset hex key wrench
P06 Bolt M6
P08 Chain tightener locking key
Description
EN