Maintenance And Inspection - Jet JTSS-1600 Mode D'emploi

When cutting small workpieces or with the saw unit inclined at 45°,
the fence profile must be used in the low position (Fig 34).
The rip fence has a micro adjust feature. Lift the handle (1) fully
and rotate the micro adjust knob (4)
When cross cutting using the parallel fence, to avoid the wood
getting stuck between the fence and the riving knife (resulting in a
highly dangerous kickback) it is necessary to position the fence so
that its end corresponds with the front of the sawblade (Fig 35).
Start the machine with precaution.
The rip fence must be parallel to the sawblade and is adjusted at
the factory.
Fig 33
Fig 34
Fig 35

8. Maintenance and inspection

General notes:
Maintenance, cleaning and repair work may only be carried out
after the machine is protected against accidental starting by
pulling the mains plug.
Repair and maintenance work on the electrical system may only be
carried out by a qualified electrician.
Clean the machine regularly.
Inspect the proper function of the dust extraction daily.
Keep the inside of the cabinet clear of sawdust and wood chips.
Make sure the motor fan and fan cover are also kept clear of
sawdust.
After a days use push the sliding table all of the way forward and
backward.
Remove rust from the table e.g. with WD-40 and a Scotch-Brite™
Hand Pad.
Never smoke while cleaning the machine, and especially when
using petrol, kerosene or other inflammable products.
This could lead to an explosion and serious burns for the operator.
All protective and safety devices must be re-attached immediately
after completed cleaning, repair and maintenance work.
Defective safety devices must be replaced immediately.
Check saw blades regularly for faults.
Replace a defective sawblades immediately.
A worn table insert must be replaced.
A worn crosscut fence end cap must be replaced.
Main drive belt tensioning:
Check regularly the condition of the belts and, if necessary, tighten
or replace.
Remove the rear machine access door.
Tension the belt by pushing the motor down with the tensioning
screw (B, Fig 36).
Fig 36