Laser Adjustment; Maintenance And Inspection; Troubleshooting; Environmental Protection - Jet JMS-10 Mode D'emploi

Fig 9
Fig 10
Press the spindle lock button (A, Fig
11) and loosen the sawblade
clamping screw (A, Fig 10) with the
supplied spanner.
Fig 11
Remove the outer clamping flange.
Replace the sawblade (B, Fig 10).
The teeth of the blade must point in
the same direction as the arrow on
the protective cover.
The flanges should be cleaned before
the new blade is fitted.
Fit the outer clamping flange back
into position and tighten the clamping
screw.
Reposition the plastic protective
cover and tighten the two screws (A,
Fig 9).

7.2 Laser Adjustment

The line laser (S, Fig 12) must be
adjusted so that the beam meets the
cutting line.
Fig.12
Attention:
Class 2 laser product, do not stare
into beam of laser.

8. Maintenance and inspection

General notes:
Maintenance, cleaning and repair
work may only be carried out after
the machine is protected against
accidental starting by pulling the
mains plug.
Repair and maintenance work on the
electrical system may only be carried
out by a qualified electrician.
Repair work on the laser beam may
only be carried out by a specialist.
Clean the machine regularly.
Inspect the proper function of the dust
extraction daily.
All protective and safety devices must
be re-attached immediately after
completed cleaning, repair and
maintenance work.
Defective safety devices must be
replaced immediately.
Replace table insert when worn.
Cleaning:
Regularly clean the machine housing
with a soft cloth preferably after each
use.
Keep the ventilation slots free from
dust and dirt.
If the dirt does not come off use a soft
cloth moistened with soapy water.
Never use solvents such as petrol,
alcohol, ammoniac water, etc. These
solvents may damage the plastic
parts.
7
Saw blades:
The servicing of saw blades should
only be performed by a trained
person.
Only use sharp saw blades.
Motor brushes:
The collector brushes are due to wear
and may need replacement.
- Disconnect the machine from the
power source, pull mains plug.
-remove the brush covers.
-Replace the collector brushes
(Jet Article Number: JMS10-110
2 pieces needed).
-reattach the brush covers.
9. Trouble shooting
Motor doesn't start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
*Motor brushes worn-
Replace brushes.
Laser doesn't work
*No electricity-
replace batteries (2 pieces AAA)
*Defective line laser-
replace entire line laser unit.
Machine vibrates excessively
*Stand on uneven surface-
adjust base for even support.
*sawblade damaged-
replace sawblade immediately
Cut is not square
*Bevel stop setting is bad.
*Workpiece fence setting is bad
Cutting surfaces is bad
*Wrong sawblade used
*resin collection on sawblade
*sawblade is dull
*workpiece inhomogeneous
*Feed pressure too high-
Do not force the workpiece.

10. Environmental protection

Protect the environment.
Your appliance contains valuable
materials which can be recovered or
recycled. Please leave it at a
specialized institution.

11. Available accessories

Refer to the JET-Pricelist
for various saw blades.