Iberspa Oasis 40 Manuel D'utilisation Et D'installation page 41

• Follow the emergency instructions on the product label in the event of an accident or
ingestion.
• Do not smoke while handling these products – they may be flammable.
• Do not store these products inside the Spa unit.
• Do not mix products. Add first one and then the other to the water, to avoid possible
reactions.
• Do not add chemical products to the water if there is someone in the Spa.
PH ADJUSTMENT
A pH index of between 7.2 and 7.6 is recommended.
The pH level measures the acidity and alkalinity: Values above 7 are alkali and below 7,
are acid.
ATTENTION
It is very important to maintain the correct pH level both for the disinfectant to
work properly and to prevent corrosion or deposits on the Spa. Any damage
caused by an inadequate pH level is not covered by your Spa guarantee.
If the level of pH is very low, the effects are as follows:
• The disinfectant will dissolve rapidly.
• The Spa kit may start to showcorrosion.
• The water may start to produce irritation in bathers.
If the level of pH is very high, the effects are as follows:
• The disinfectant is less effective.
• The acrylic and the kit may start to showscaling.
• The water may turn cloudy.
• The filter cartridge pores may be obstructed.
Check the pH of the water with the pH analyser case on a daily basis.
If the pH is above these indexes, use pH MINOR SPA.Wait for two hours before doing the
pH test. When the pH index has been adjusted to the values indicated above, proceed to
the next step.
WATER DESINFECTION
Disinfecting the water is of utmost importance in order to destroy algae, bacteria and any
other organisms that may grow in the water. However, excessive disinfection can cause
irritations to the skin and eyes.
ENG
41