Annexe C Informations Juridiques; Réglementation - HP DeskJet 970C Série Guide De L'utilisateur

C
Informations
juridiques
Réglementation
Hewlett-Packard Company
Modèles C6429A, C6429B
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
Pursuant to Part 15.21 of the FCC Rules,
any changes or modifications to this
equipment not expressly approved by
Hewlett-Packard Company may cause
harmful interference, and void your
authority to operate this equipment. Use
of a shielded data cable is required to
comply with the Class B limits of Part 15 of
the FCC Rules.
For further information, contact:
Hewlett-Packard Company
Manager of Corporate Product
Regulations
3000 Hanover Street
Palo Alto, Ca 94304
(415) 857-1501
NOTE: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to part 15
of the FCC rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the
interferences by one or more of the
following measures:
•
Reorient or relocate the receiving
antenna.
•
Increase the separation between the
equipment and the receiver.
•
Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
•
Consult the dealer or an experienced
radio/TV technician for help.
LED Indicator Statement.
The display LEDs meet the requirements
of EN 60825-1.
67