TERMA DRL E-Comfort MEG 1.0 wit Mode D'emploi page 24

Anti-freeze function
When the device is off and the temperature
surrounding the temperature sensor drops
to below 6° C, the device will switch on au-
tomatically. This is to prevent the heating
agent inside the radiator from freezing. The
activation of Anti-freeze mode is indicated
by the blinking of the middle diode.
Dryer function
The Dryer turns the device on for 2 hours,
e.g. in order to dry a towel. After this peri-
od of time the device automatically switch-
es to the mode to which it was set before
the dryer mode.
In order to activate the dryer mode, press
and hold the button (also when the heating
element is off) – the device will start work-
ing and maintain the most recent temper-
ature setting. You can now freely adjust de-
sired temperature level (buttons
After 2 hrs heater will revert to the previous
setting (before dryer function activation).
To use 2 hrs timer heating element must be
switched off. Switch it on by pressing and
holding button. After 2 hrs heater will
switch off automatically.
Press button at any time to interrupt the
dryer mode.
24
User manual MEG, DRY, MOA, REG 2, REG 3
Remote control mode
(wireless communication)
If the device is located in a room with an ex-
ternal IR controller suitable for communica-
tion with the heating element, the first signal
received by the heating element will auto-
matically activate the reception mode. The
device will maintain the temperature indi-
cated by the external controller while con-
tinuing to limit the radiator temperature so
that it does not exceed 60°C. The remote
control mode is indicated by the middle di-
ode. In case of communication loss longer
than 25 minutes, the device will automati-
cally switch back to the manual mode, and
continue to operate according to the most
recent setting. Any new signal received by
the heating element, will switch it back to
the remote control mode.
The dryer function can be activated in the
remote control mode (when the dryer func-
tion is deactivated, the heating element will
resume the reception of signals from the ex-
and ).
ternal controller).
Calibrating the temperature span
same as MOA
Problem solving
same as MOA