Problem Solving - TERMA DRL E-Comfort MEG 1.0 wit Mode D'emploi

Problem solving

Problem
The device is plugged in,
no diodes are on.
Heating element is not
heating, outside diodes
are winking alternately.
Heating element is heating
despite turning it off with
the on/off button.
If the problem continues please contact Your local Distributor.
EN
Possible cause
Problem with the
connection.
Temperature sensor has
been damaged.
Overheating of device.
Damaged Electronics.
Solution
Check the connection of
the power wire, the plug
and the socket.
Disconnect the device
completely, wait until the
radiator cools down and
then re-connect it.
Check and confirm that
the heating element's out-
put does not exceed the
recommended output of
your radiator. Check and
reduce the water tem-
perature in the central
heating system-must not
exceed 82°. In electric-only
version check, if the radi-
ator is properly filled with
the heating agent.
Disconnect the device
completely, wait until the
radiator cools down and
then re-connect it.
15