TERMA DRL E-Comfort MEG 1.0 wit Mode D'emploi page 14

MEG
Turning on the device will result in the heat-
ing of the radiator up to the set tempera-
ture. After reaching the set temperature the
device will turn off and on regularly in order
to maintain the set temperature.
The construction of the device as well as
the physical characteristics of the heating
agent inside the radiator influence the way
in which the heat is distributed — the tem-
perature of the bottom pipes on the radia-
tor (especially the two located at the very
bottom of the radiator) may be lower than
the temperature of the remaining parts of
the radiator — this is normal.
Temperature increase
In order to increase the temperature of the
radiator, press
required; the right number of diodes will
start blinking. The last blinking diode indi-
cates the set temperature, whilst the last.
14
User manual MEG, DRY, MOA, REG 2, REG 3
temperature regulation
turn on / off button
once or several times as
Temperature decrease
In order to decrease the temperature of the
radiator, press once or several times as re-
quired; the right number of diodes will start
blinking. The last diode that which shines
constantly indicates the set temperature
whilst the last blinking diode indicates the
current temperature. The following diodes
will start fading on reaching subsequent
temperature levels.
Anti-freeze function
(anti-freeze protection)
When the device is off and the temperature
around temperature sensor drops down be-
low 6° C, the device will switch on automat-
ically. This is to prevent the heating agent
inside the radiator from freezing. Activating
Anti-freeze mode is indicated by winking of
the middle diode.